Jacket measurements

The following is a guide on how to take the measurements required for jacket fitting.

They are taken from the Cutters Guide To Lounge Jackets and are designed to help me create a block from which I can cut your jacket.


All measurements should be taken in Inches

The first measurements to take are your Chest, Waist and Seat. These should be the full circumference of your body.

When doing this, make sure you are relaxed and breathed out. If you take it while taking a sharp intake of breathe – it will only fit you when you do the same!

Chest (A) should be taken just under the arms (full circumference).

Waist (B) should be taken at the belt level of a well fitting trousers (full circumference).

Seat (C) should be taken at the widest part of your pelvis (full circumference).

Now take your Across Chest measurement.

Across Chest (D) should be taken just above the under arm.

We now need to do your Scye Depth, Natural Waist and Full Length. These are slightly tricky, and are best referenced to when the Chest, Waist and Seat were taken.

All measurements are taken from the nape of the neck at (E).

 Scye Depth (E to N) should be measured down to the level of the under arm.

Natural Waist (E to F) should be measured down to the level of the belt of a well fitting pair of trousers.

Full Length (E to G) should be measured to the required level of the jacket hem. This will vary depending on the garment you are ordering.


The next measurements, Across Back, Centre of Back to Elbow & Cuff, should be taken carefully, with your arm raised and your fist to your chest.

Across Back (H to I) should be measured centered on the the arm hole, from the centre of the back to the arm.


Centre Of Back to Elbow (H to J) should be continued to the point of the elbow.

Centre Of Back to Cuff (H to K) should be continued to cuff, which should be at the round bone on your wrist.


Shoulder to Cuff as a backup measurement, please measure with your arm vertically by your side from the top of your arm (where a sleeve would meet the shoulder of a jacket) down to your desired cuff length.

Things get a little complicated now, so bear with me!


Over Shoulder to Shoulder Apex (L to O) and Over Shoulder to Under Arm (L to P) is taken diagonally across the shoulder, starting from the nape of the neck (L) to level with the lowest point of the armhole (P).
On the way, take the measurement to the top of the shoulder (O)

Finally, I need the measurement from
Centre Back to Shoulder Apex (N to O)





Once you have taken all these measurements, please fill them into the email I have sent you and return them to me